福建天利高新材料有限公司 已通过实名认证

高性能酚醛泡沫保温板High-performance phenolic foam insulation board

我公司多年来专业致力于酚醛泡沫的研发生产，在酚醛泡沫的研发、生产、使用上积累了大量的经验，根据这些经验我们总结了酚醛泡沫的如下性能特点：

Our company has been dedicated to the research and development of phenolic foam for many years and accumulated a great deal of experience in theresearch,production and use of phenolic foam. Based on these experiences, we summarized the following as performance characteristics of phenolic foam:

1极低的导热系数

酚醛泡沫的导热系数约为0.025w/（m.k），接近聚氨酯泡沫材料，优于挤塑板、聚苯板、岩棉、玻璃棉、泡沫玻璃、真金板等材料。而且我们公司还研发出了导热系数低于0.023w/（m.k）的酚醛泡沫保温板，应用于被动房可大大降低保温层的厚度。

1 Very low thermal conductivity

The thermal conductivity of Phenolic foam is about 0.025w / (m.k), close to the data of polyurethane foam, better than the extruded board,polystyreneboard, rock wool, glass wool, foam glass and other materials. And our company has also developed a thermal conductivity of phenolic foam insulation boards which less than 0.023w / (m.k),will be usedin passive housing to reduce the thickness of the insulation layer.

2良好的尺寸稳定性

酚醛泡沫属于热固性材料，无论在高低温（使用温度-250℃~150℃），还是长期使用后，尺寸稳定性都非常好。这点在外墙保温，尤其是薄抹灰系统中，显得尤为重要。

如果保温板尺寸稳定性不好，容易造成表面聚合物砂浆开裂以及保温板与聚合物砂浆脱层，最终导致外墙保温层脱落或屋面开裂渗水。

酚醛泡沫保温板的尺寸稳定性明显优于挤塑板、聚氨酯等材料。

2 good dimensional stability

Phenolic foam is thermosetting material, no matter in high and low temperature ( temperature range from -250 ℃to150℃) or long-term use, the dimensionalstability is very good. This is very important in the external wall insulation, especially in plastering system.  If the size stability ofinsulation board is not good, likely to cause thepolymer mortar surface cracking problem and insulation layer delamination from the polymer mortar, and ultimately lead to the insulation layershedding from outer wall or roof cracking and waterseepage problem. The dimensional stability of phenolic foam insulation board is much better than extruded board, polyurethane and othermaterials.

3优异的防火性能

酚醛泡沫生产时无需添加任何阻燃剂，氧指数大于40，高于一般的有机泡沫保温隔热材料。酚醛泡沫良好的防火性能表现在两方面：一是遇火不燃，仅遇火部分碳化，表面无滴落物、无卷曲、无熔化现象、不具有火焰传播性；二是遇火时发烟量低（**烟密度（SDR）不超过5），而且由于无需添加阻燃剂，几乎无毒性烟气产生，所以发生火灾时也便于消防员救援。

经测试，25mm厚的酚醛泡沫板在经受1500℃的火焰喷射10min后，仅表面略有碳化却烧不穿，既不会着火更不会散发浓烟和毒气。

3 excellent fire resistance performance

Phenolic foam\'s production is without adding any flame retardant, oxygen index is more than 40, higher than the normal organic foam insulationmaterials.The good fire resistance performance of the phenolic foam shown in two ways: Firstly, don\'t ignite in case of fire, only partial carbonization, there is no drop on the surface , no curl, nomelting,without  flame spread; secondly,  Low smoke (maximum smoke density (SDR)is  no more than 5), and almost no toxic smoke generated  due to no flame retardants added intheproduction, so it is also easy for firefighters rescue given on a fire.

According to the testing, 25mm thick phenolic foam board under 1500 ℃flame spray for 10min, there is only a little carbonized on thesurface but notburned out, no flame and no toxic smoke.

4极低的热扩散系数

什么是热扩散系数？

以物体受热升温的情况为例来分析。在物体受热升温的非稳态导热过程中，进入物体的热量沿途不断地被吸收而使局部温度升高，在此过程持续到物体内部各点温度全部相同为止。也是材料传播温度变化能力大小的指标，因而有导温系数之称。

热扩散系数越小材料中温度变化传播得越缓慢。

4 Extremely low thermal diffusivity

What is thermal diffusivity?

Take the case of heating up the object as an example to analyze. In the heat transfer process, the heat entering the object is continuously absorbedalongthe way to make local temperature rise,  this process will be kept till the temperature inside the object are all the same. It is also the indicators which show the capacity of thematerialtransit the temperature,  thus called the thermal conductivity.

The smaller the thermal diffusivity, the slower the propagation of the temperature change in the material.

（以上数值为我公司从清华大学热流体实验室订购的热扩散系数检测仪检测所得）

(The above values from the thermal diffusion coefficient detector ordered from Thermal Fluid Laboratory of Tsinghua University )

（热扩散系数检测仪）

如果保温隔热材料具有越低的热扩散系数，温度从一侧传递到另一侧需要更多的时间。所以对保温隔热材料而言，除了要求有较低的导热系数之外，也应该要求有较低的热扩散系数。因此，热扩散系数也是除导热系数之外，影响保温隔热材料实际应用效果的重要的参数指标。

If the thermal insulating material has a lower thermal diffusivity, it takes more time for the temperature to pass from one side to the other.Therefore,thermal insulation materials requires not only has a lower thermal conductivity, but also require a lower thermal diffusivity.

Therefore, the thermal diffusion coefficient is another important parameter index impact thel practical application of the  thermalinsulationmaterial .

5耐老化，与建筑同寿命。

酚醛泡沫本身抗腐蚀抗老化，几乎能够耐所有无机酸、有机酸、有机溶剂的侵蚀，长期暴露于阳光下，其他无明显老化现象，具有较好的耐老化性。

而且经观察测试，外墙外保温薄抹灰系统中的酚醛泡沫保温板在自然现实环境中，其闭孔率和泡孔结构稳定，几乎没有变化。

上世纪90年代以来，酚醛泡沫就开始应用于英美等发达国家的建筑保温，良好的酚醛泡沫性能可以保证与建筑同寿命。

5 anti-aging, and same life period with the building

Phenolic foam itself is anti-corrosion and anti-aging, almost can against all inorganic acids, organic acids, organic solvents erosion, long-termexposureto sunlight, no other significant aging, with good aging resistance.

After observing and testing, the phenolic foam insulation board applied in exterior wall thermal insulation thin plaster system has almost no changeinits closed porosity and stabe cell structure in the natural environment.

Since 1990s, phenolic foam was used for building insulation in the United States and other developed countries,  good phenolic foam performancecanguarantee the same life with building.

酚醛泡沫防火保温板的应用领域： 
       酚醛保温材料最突出的优势是除了具有优良的保温效果外还具有防火功能、耐低温高温性能、尺寸稳定性等，因此酚醛保温材料是更适合于有苛刻要求的环境条件下使用的高性能材料，主要可以应用在建筑保温、管道保温、电器保温、设备保温、冷藏保温以及其他聚氨酯、挤塑板、聚苯乙烯、岩棉应用领域的保温。

酚醛泡沫对比聚氨酯（PU）、挤塑板（XPS）、聚苯乙烯（EPS）的优势：

       PU、XPS、EPS等都是易燃保温材料，遇高温收缩变形，而酚醛泡沫不燃防火，可以适应高温使用。 
酚醛泡沫对比岩棉、玻璃棉、石棉的优势：

       岩棉、玻璃棉等保温材料虽然不燃，但是保温性能差，且不环保，接触人体皮肤会造成刺痒，时间久了会致癌。同时，这些无机材料吸水率高，容易吸水，密度高。而酚醛泡沫可以解决这些问题。